All posts

Sanding, priming and painting

Every good paint job starts with good prep: sanding, filling and priming.

Resin prints come off the printer rough. Before a single drop of paint, every part goes through the same steps.

Prep

  • Supports off. With water-washable resin, they pop off cleanly once the print is washed.
  • Drain holes filled. Hollow parts need drain holes, which get filled with epoxy putty.
  • Sanding. Each part is sanded up to P1000 until the surface is smooth.
  • Priming. Parts are mounted and given light, even coats of primer.

Paint

Then comes the fun part: colour, with Vallejo paints, and a coat of varnish to protect it. Finally everything is glued and assembled.

Keep reading

All posts